From ea0de4ec5489da0fe738b274effac4f950e93d76 Mon Sep 17 00:00:00 2001 From: Dylan Rajaratnam Date: Mon, 17 Nov 2014 09:17:45 -0300 Subject: [PATCH] [media] img-ir/hw: Always read data to clear buffer A problem was found on Polaris where if the unit it booted via the power button on the infrared remote then the next button press on the remote would return the key code used to power on the unit. The sequence is: - The polaris powered off but with the powerdown controller (PDC) block still powered. - Press power key on remote, IR block receives the key. - Kernel starts, IR code is in IMG_IR_DATA_x but neither IMG_IR_RXDVAL or IMG_IR_RXDVALD2 are set. - Wait any amount of time. - Press any key. - IMG_IR_RXDVAL or IMG_IR_RXDVALD2 is set but IMG_IR_DATA_x is unchanged since the powerup key data was never read. This is worked around by always reading the IMG_IR_DATA_x in img_ir_set_decoder(), rather than only when the IMG_IR_RXDVAL or IMG_IR_RXDVALD2 bit is set. Signed-off-by: Dylan Rajaratnam Signed-off-by: James Hogan Cc: # v3.15+ Signed-off-by: Mauro Carvalho Chehab --- drivers/media/rc/img-ir/img-ir-hw.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/drivers/media/rc/img-ir/img-ir-hw.c b/drivers/media/rc/img-ir/img-ir-hw.c index ec49f94425f..9db065344b4 100644 --- a/drivers/media/rc/img-ir/img-ir-hw.c +++ b/drivers/media/rc/img-ir/img-ir-hw.c @@ -541,10 +541,12 @@ static void img_ir_set_decoder(struct img_ir_priv *priv, if (ir_status & (IMG_IR_RXDVAL | IMG_IR_RXDVALD2)) { ir_status &= ~(IMG_IR_RXDVAL | IMG_IR_RXDVALD2); img_ir_write(priv, IMG_IR_STATUS, ir_status); - img_ir_read(priv, IMG_IR_DATA_LW); - img_ir_read(priv, IMG_IR_DATA_UP); } + /* always read data to clear buffer if IR wakes the device */ + img_ir_read(priv, IMG_IR_DATA_LW); + img_ir_read(priv, IMG_IR_DATA_UP); + /* stop the end timer and switch back to normal mode */ del_timer_sync(&hw->end_timer); hw->mode = IMG_IR_M_NORMAL; -- 2.41.0