From e4fb3b88ebf21e6127ed0e91336752352ba0931e Mon Sep 17 00:00:00 2001 From: Heikki Krogerus Date: Wed, 10 Apr 2013 16:58:26 +0300 Subject: [PATCH] serial: 8250_dma: Use dmaengine helpers to get the slave channels The helper functions in dmaengine API allow the drivers to request slave channels without the filter parameters. They will attempt to extract the needed DMA client information from DT or ACPI, but if such information is not available the filter parameters can still be used. Signed-off-by: Heikki Krogerus Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/8250/8250_dma.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) diff --git a/drivers/tty/serial/8250/8250_dma.c b/drivers/tty/serial/8250/8250_dma.c index 66430614510..fdb6139e8c1 100644 --- a/drivers/tty/serial/8250/8250_dma.c +++ b/drivers/tty/serial/8250/8250_dma.c @@ -156,14 +156,18 @@ int serial8250_request_dma(struct uart_8250_port *p) dma_cap_set(DMA_SLAVE, mask); /* Get a channel for RX */ - dma->rxchan = dma_request_channel(mask, dma->fn, dma->rx_param); + dma->rxchan = dma_request_slave_channel_compat(mask, + dma->fn, dma->rx_param, + p->port.dev, "rx"); if (!dma->rxchan) return -ENODEV; dmaengine_slave_config(dma->rxchan, &dma->rxconf); /* Get a channel for TX */ - dma->txchan = dma_request_channel(mask, dma->fn, dma->tx_param); + dma->txchan = dma_request_slave_channel_compat(mask, + dma->fn, dma->tx_param, + p->port.dev, "tx"); if (!dma->txchan) { dma_release_channel(dma->rxchan); return -ENODEV; -- 2.41.0