From bc0f03ea579d78f845a44a0c611806da64057b03 Mon Sep 17 00:00:00 2001 From: Saravanan Dhanabal Date: Fri, 26 Mar 2010 12:53:33 +0200 Subject: [PATCH] wl1271: Fix msleep() delay while waiting for completion After last transmission, the device goes to sleep earlier than the configured dynamic power save timeout. If timeout is set to 400ms, device enters into sleep mode at around 330ms since from last TX. This patch removes the msleep(1), which causes the delay after ELP wakeup. Replaced with udelay(10), the variation is around 7-10ms. Signed-off-by: Saravanan Dhanabal Reviewed-by: Juuso Oikarinen Signed-off-by: Luciano Coelho Signed-off-by: John W. Linville --- drivers/net/wireless/wl12xx/wl1271_cmd.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/wl12xx/wl1271_cmd.c b/drivers/net/wireless/wl12xx/wl1271_cmd.c index 0cb4cbb0039..f11f9f47ffd 100644 --- a/drivers/net/wireless/wl12xx/wl1271_cmd.c +++ b/drivers/net/wireless/wl12xx/wl1271_cmd.c @@ -36,6 +36,8 @@ #include "wl1271_cmd.h" #include "wl1271_event.h" +#define WL1271_CMD_POLL_COUNT 5 + /* * send command to firmware * @@ -52,6 +54,7 @@ int wl1271_cmd_send(struct wl1271 *wl, u16 id, void *buf, size_t len, u32 intr; int ret = 0; u16 status; + u16 poll_count = 0; cmd = buf; cmd->id = cpu_to_le16(id); @@ -73,7 +76,11 @@ int wl1271_cmd_send(struct wl1271 *wl, u16 id, void *buf, size_t len, goto out; } - msleep(1); + udelay(10); + poll_count++; + if (poll_count == WL1271_CMD_POLL_COUNT) + wl1271_info("cmd polling took over %d cycles", + poll_count); intr = wl1271_read32(wl, ACX_REG_INTERRUPT_NO_CLEAR); } -- 2.46.0