From 99dcadede42f8898d4c963ef69192ef4b9b76ba8 Mon Sep 17 00:00:00 2001 From: Fenghua Yu Date: Wed, 11 Nov 2009 07:23:06 -0800 Subject: [PATCH] intel-iommu: Support PCIe hot-plug To support PCIe hot plug in IOMMU, we register a notifier to respond to device change action. When the notifier gets BUS_NOTIFY_UNBOUND_DRIVER, it removes the device from its DMAR domain. A hot added device will be added into an IOMMU domain when it first does IOMMU op. So there is no need to add more code for hot add. Without the patch, after a hot-remove, a hot-added device on the same slot will not work. Signed-off-by: Fenghua Yu Tested-by: Yinghai Lu Signed-off-by: David Woodhouse --- drivers/pci/intel-iommu.c | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+) diff --git a/drivers/pci/intel-iommu.c b/drivers/pci/intel-iommu.c index 7fe5f7920ca..1840a0578a4 100644 --- a/drivers/pci/intel-iommu.c +++ b/drivers/pci/intel-iommu.c @@ -3215,6 +3215,33 @@ static int __init init_iommu_sysfs(void) } #endif /* CONFIG_PM */ +/* + * Here we only respond to action of unbound device from driver. + * + * Added device is not attached to its DMAR domain here yet. That will happen + * when mapping the device to iova. + */ +static int device_notifier(struct notifier_block *nb, + unsigned long action, void *data) +{ + struct device *dev = data; + struct pci_dev *pdev = to_pci_dev(dev); + struct dmar_domain *domain; + + domain = find_domain(pdev); + if (!domain) + return 0; + + if (action == BUS_NOTIFY_UNBOUND_DRIVER && !iommu_pass_through) + domain_remove_one_dev_info(domain, pdev); + + return 0; +} + +static struct notifier_block device_nb = { + .notifier_call = device_notifier, +}; + int __init intel_iommu_init(void) { int ret = 0; @@ -3267,6 +3294,8 @@ int __init intel_iommu_init(void) register_iommu(&intel_iommu_ops); + bus_register_notifier(&pci_bus_type, &device_nb); + return 0; } -- 2.41.0