From 453cdb61c015f80e492dda217110353cd09eef18 Mon Sep 17 00:00:00 2001 From: Michal Kazior Date: Fri, 13 Dec 2013 10:44:43 +0100 Subject: [PATCH] ath10k: fix band reporting for mgmt CCK frames on 5GHz Although CCK modulation isn't expected for 11a if it happened it made ath10k report wrong band (2GHz) for a mgmt frame that were actually received on 5Ghz band. Frequency would also decoded incorrectly too. In case of 5GHz-only devices this triggered mac80211 WARN_ON because there was no according sband pointer to be found. The patch should fix delivery of such frames by using different means to acquire band parameter. Signed-off-by: Michal Kazior Signed-off-by: Kalle Valo --- drivers/net/wireless/ath/ath10k/wmi.c | 21 ++++++++++++++++++++- 1 file changed, 20 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c index 9ea333a7789..3ec6c9a84e8 100644 --- a/drivers/net/wireless/ath/ath10k/wmi.c +++ b/drivers/net/wireless/ath/ath10k/wmi.c @@ -875,6 +875,7 @@ static int ath10k_wmi_event_mgmt_rx(struct ath10k *ar, struct sk_buff *skb) struct wmi_mgmt_rx_event_v2 *ev_v2; struct wmi_mgmt_rx_hdr_v1 *ev_hdr; struct ieee80211_rx_status *status = IEEE80211_SKB_RXCB(skb); + struct ieee80211_channel *ch; struct ieee80211_hdr *hdr; u32 rx_status; u32 channel; @@ -927,7 +928,25 @@ static int ath10k_wmi_event_mgmt_rx(struct ath10k *ar, struct sk_buff *skb) if (rx_status & WMI_RX_STATUS_ERR_MIC) status->flag |= RX_FLAG_MMIC_ERROR; - status->band = phy_mode_to_band(phy_mode); + /* HW can Rx CCK rates on 5GHz. In that case phy_mode is set to + * MODE_11B. This means phy_mode is not a reliable source for the band + * of mgmt rx. */ + + ch = ar->scan_channel; + if (!ch) + ch = ar->rx_channel; + + if (ch) { + status->band = ch->band; + + if (phy_mode == MODE_11B && + status->band == IEEE80211_BAND_5GHZ) + ath10k_dbg(ATH10K_DBG_MGMT, "wmi mgmt rx 11b (CCK) on 5GHz\n"); + } else { + ath10k_warn("using (unreliable) phy_mode to extract band for mgmt rx\n"); + status->band = phy_mode_to_band(phy_mode); + } + status->freq = ieee80211_channel_to_frequency(channel, status->band); status->signal = snr + ATH10K_DEFAULT_NOISE_FLOOR; status->rate_idx = get_rate_idx(rate, status->band); -- 2.46.0