From 374abf2cb16a9df8be96675c606996458872e8b3 Mon Sep 17 00:00:00 2001 From: Bartlomiej Zolnierkiewicz Date: Mon, 11 Jun 2007 11:40:07 +0200 Subject: [PATCH] pata_it821x: (partially) fix DMA in RAID mode Code intended to check DMA status was checking DMA command register. Moreover firmware seems to "forget" to set DMA capable bit for the slave device (at least in RAID mode but without ITE RAID volumes) so check device ID for DMA capable bit when deciding whether to use DMA and remove DMA status check completely. Thanks to Pavol Simo for the bugreport and testing the initial fix. This change unfortunately still doesn't fix DMA in RAID mode (which works fine with IDE it821x) but Alan is working on the missing pieces (pata_it821x vs libata EH issues). Signed-off-by: Bartlomiej Zolnierkiewicz Acked-by: Alan Cox Cc: Tejun Heo Signed-off-by: Jeff Garzik --- drivers/ata/pata_it821x.c | 11 +++-------- 1 file changed, 3 insertions(+), 8 deletions(-) diff --git a/drivers/ata/pata_it821x.c b/drivers/ata/pata_it821x.c index b3456d7a592..525c9c14289 100644 --- a/drivers/ata/pata_it821x.c +++ b/drivers/ata/pata_it821x.c @@ -2,6 +2,7 @@ * pata_it821x.c - IT821x PATA for new ATA layer * (C) 2005 Red Hat Inc * Alan Cox + * (C) 2007 Bartlomiej Zolnierkiewicz * * based upon * @@ -79,7 +80,7 @@ #define DRV_NAME "pata_it821x" -#define DRV_VERSION "0.3.6" +#define DRV_VERSION "0.3.7" struct it821x_dev { @@ -460,14 +461,8 @@ static unsigned int it821x_passthru_qc_issue_prot(struct ata_queued_cmd *qc) static int it821x_smart_set_mode(struct ata_port *ap, struct ata_device **unused) { - int dma_enabled = 0; int i; - /* Bits 5 and 6 indicate if DMA is active on master/slave */ - /* It is possible that BMDMA isn't allocated */ - if (ap->ioaddr.bmdma_addr) - dma_enabled = ioread8(ap->ioaddr.bmdma_addr + ATA_DMA_CMD); - for (i = 0; i < ATA_MAX_DEVICES; i++) { struct ata_device *dev = &ap->device[i]; if (ata_dev_enabled(dev)) { @@ -476,7 +471,7 @@ static int it821x_smart_set_mode(struct ata_port *ap, struct ata_device **unused dev->dma_mode = XFER_MW_DMA_0; /* We do need the right mode information for DMA or PIO and this comes from the current configuration flags */ - if (dma_enabled & (1 << (5 + i))) { + if (ata_id_has_dma(dev->id)) { ata_dev_printk(dev, KERN_INFO, "configured for DMA\n"); dev->xfer_mode = XFER_MW_DMA_0; dev->xfer_shift = ATA_SHIFT_MWDMA; -- 2.46.0