From: Kalle Valo Date: Tue, 17 Jan 2012 18:08:56 +0000 (+0200) Subject: ath6kl: add ATH6KL_CONF_UART_DEBUG X-Git-Url: https://openfabrics.org/gitweb/?a=commitdiff_plain;h=f29af97853599e9537191c4f33f8ac87f3f503a9;p=~shefty%2Frdma-dev.git ath6kl: add ATH6KL_CONF_UART_DEBUG Add ATH6KL_CONF_UART_DEBUG which is set whenever uart_debug module parameter is enabled. This way we can keep the uart_debug parameter static when core.c file is introduced. Signed-off-by: Kalle Valo --- diff --git a/drivers/net/wireless/ath/ath6kl/core.h b/drivers/net/wireless/ath/ath6kl/core.h index bdeb254c259..78c0402e2d3 100644 --- a/drivers/net/wireless/ath/ath6kl/core.h +++ b/drivers/net/wireless/ath/ath6kl/core.h @@ -197,6 +197,7 @@ struct ath6kl_fw_ie { #define ATH6KL_CONF_ENABLE_11N BIT(2) #define ATH6KL_CONF_ENABLE_TX_BURST BIT(3) #define ATH6KL_CONF_SUSPEND_CUTPOWER BIT(4) +#define ATH6KL_CONF_UART_DEBUG BIT(5) enum wlan_low_pwr_state { WLAN_POWER_STATE_ON, diff --git a/drivers/net/wireless/ath/ath6kl/init.c b/drivers/net/wireless/ath/ath6kl/init.c index 7e56a6aa70b..2804921d5d8 100644 --- a/drivers/net/wireless/ath/ath6kl/init.c +++ b/drivers/net/wireless/ath/ath6kl/init.c @@ -469,7 +469,7 @@ int ath6kl_configure_target(struct ath6kl *ar) u8 fw_iftype, fw_mode = 0, fw_submode = 0; int i, status; - param = uart_debug; + param = !!(ar->conf_flags & ATH6KL_CONF_UART_DEBUG); if (ath6kl_bmi_write(ar, ath6kl_get_hi_item_addr(ar, HI_ITEM(hi_serial_enable)), (u8 *)¶m, 4)) { ath6kl_err("bmi_write_memory for uart debug failed\n"); @@ -1775,6 +1775,9 @@ int ath6kl_core_init(struct ath6kl *ar) if (suspend_cutpower) ar->conf_flags |= ATH6KL_CONF_SUSPEND_CUTPOWER; + if (uart_debug) + ar->conf_flags |= ATH6KL_CONF_UART_DEBUG; + ar->wiphy->flags |= WIPHY_FLAG_SUPPORTS_FW_ROAM | WIPHY_FLAG_HAVE_AP_SME | WIPHY_FLAG_HAS_REMAIN_ON_CHANNEL |