From: Kleber Sacilotto de Souza Date: Wed, 4 May 2011 13:05:11 +0000 (+0000) Subject: ehea: fix wrongly reported speed and port X-Git-Tag: v2.6.39~61^2~12 X-Git-Url: https://openfabrics.org/gitweb/?a=commitdiff_plain;h=dcbe14b91a920657ff3a9ba0efb7c5b5562f956a;p=~shefty%2Frdma-dev.git ehea: fix wrongly reported speed and port Currently EHEA reports to ethtool as supporting 10M, 100M, 1G and 10G and connected to FIBRE independent of the hardware configuration. However, when connected to FIBRE the only supported speed is 10G full-duplex, and the other speeds and modes are only supported when connected to twisted pair. Signed-off-by: Kleber Sacilotto de Souza Acked-by: Breno Leitao Signed-off-by: David S. Miller --- diff --git a/drivers/net/ehea/ehea_ethtool.c b/drivers/net/ehea/ehea_ethtool.c index 3e2e734fecb..f3bbdcef338 100644 --- a/drivers/net/ehea/ehea_ethtool.c +++ b/drivers/net/ehea/ehea_ethtool.c @@ -55,15 +55,20 @@ static int ehea_get_settings(struct net_device *dev, struct ethtool_cmd *cmd) cmd->duplex = -1; } - cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_1000baseT_Full - | SUPPORTED_100baseT_Full | SUPPORTED_100baseT_Half - | SUPPORTED_10baseT_Full | SUPPORTED_10baseT_Half - | SUPPORTED_Autoneg | SUPPORTED_FIBRE); - - cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_Autoneg - | ADVERTISED_FIBRE); + if (cmd->speed == SPEED_10000) { + cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_FIBRE); + cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_FIBRE); + cmd->port = PORT_FIBRE; + } else { + cmd->supported = (SUPPORTED_1000baseT_Full | SUPPORTED_100baseT_Full + | SUPPORTED_100baseT_Half | SUPPORTED_10baseT_Full + | SUPPORTED_10baseT_Half | SUPPORTED_Autoneg + | SUPPORTED_TP); + cmd->advertising = (ADVERTISED_1000baseT_Full | ADVERTISED_Autoneg + | ADVERTISED_TP); + cmd->port = PORT_TP; + } - cmd->port = PORT_FIBRE; cmd->autoneg = port->autoneg == 1 ? AUTONEG_ENABLE : AUTONEG_DISABLE; return 0;