From: Mauro Carvalho Chehab Date: Sun, 3 Mar 2013 10:49:50 +0000 (-0300) Subject: [media] cx231xx: Improve signal reception for PV SBTVD X-Git-Tag: v3.10-rc1~136^2~640 X-Git-Url: https://openfabrics.org/gitweb/?a=commitdiff_plain;h=84c09d723c30db7801433e1741b628e23cb3fecd;p=~emulex%2Finfiniband.git [media] cx231xx: Improve signal reception for PV SBTVD Instead of using 3.3 MHz IF, use 4MHz. That's the standard value for the demod, and, while it can be adjusted, 3.3 MHz is out of the recommended range. So, let's stick with the default. With regards to the IF voltage level, instead of using 0.5 V(p-p) for IF, use 2V, giving a 12dB gain. The rationale is that, on PixelView SBTVD Hybrid, even 2V(p-p) would be in the nominal range for IF, as the maximum range on this particular device is 3V. A higher gain here should help to improve reception under weak signals. Signed-off-by: Mauro Carvalho Chehab --- diff --git a/drivers/media/usb/cx231xx/cx231xx-dvb.c b/drivers/media/usb/cx231xx/cx231xx-dvb.c index 7c4e360ba9b..14e26106fd7 100644 --- a/drivers/media/usb/cx231xx/cx231xx-dvb.c +++ b/drivers/media/usb/cx231xx/cx231xx-dvb.c @@ -89,8 +89,8 @@ static struct tda18271_std_map cnxt_rde253s_tda18271_std_map = { }; static struct tda18271_std_map mb86a20s_tda18271_config = { - .dvbt_6 = { .if_freq = 3300, .agc_mode = 3, .std = 4, - .if_lvl = 7, .rfagc_top = 0x37, }, + .dvbt_6 = { .if_freq = 4000, .agc_mode = 3, .std = 4, + .if_lvl = 0, .rfagc_top = 0x37, }, }; static struct tda18271_config cnxt_rde253s_tunerconfig = {