From: Roger Quadros Date: Mon, 15 Apr 2013 11:50:34 +0000 (+0300) Subject: USB: ehci-omap: Don't select any PHY driver X-Git-Tag: v3.10-rc1~190^2~37 X-Git-Url: https://openfabrics.org/gitweb/?a=commitdiff_plain;h=7c4ebe68ecdeaa6b2846863c29e248615c366e19;p=~emulex%2Finfiniband.git USB: ehci-omap: Don't select any PHY driver Don't select NOP_USB_XCEIV. Instead, board config must select USB_PHY and the appropriate PHY driver. Also add a hint in Kconfig so that users enabling this driver manually enable the right PHY drivers as well. Gets rid of the below warnings when USB_EHCI_HCD_OMAP is enabled. warning: (USB_EHCI_HCD_OMAP) selects NOP_USB_XCEIV which has unmet direct dependencies (USB_SUPPORT && USB_PHY) warning: (USB_EHCI_HCD_OMAP) selects NOP_USB_XCEIV which has unmet direct dependencies (USB_SUPPORT && USB_PHY) Signed-off-by: Roger Quadros Acked-by: Alan Stern Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig index c0be25c8e61..c558472036b 100644 --- a/drivers/usb/host/Kconfig +++ b/drivers/usb/host/Kconfig @@ -150,11 +150,13 @@ config USB_EHCI_MXC config USB_EHCI_HCD_OMAP tristate "EHCI support for OMAP3 and later chips" depends on ARCH_OMAP - select NOP_USB_XCEIV default y ---help--- Enables support for the on-chip EHCI controller on OMAP3 and later chips. + If your system uses a PHY on the USB port, you will need to + enable USB_PHY and the appropriate PHY driver as well. Most + boards need the NOP_USB_XCEIV PHY driver. config USB_EHCI_HCD_ORION tristate "Support for Marvell EBU on-chip EHCI USB controller"