serial: 8250: remove a few lines of dead code

Support for the WindRiver SBC8560 board was removed in v3.6. But there
are still a few lines depending on its obsolete Kconfig macro. Remove
these now.

Signed-off-by: Paul Bolle <pebolle@tiscali.nl>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/tty/serial/8250/8250.h b/drivers/tty/serial/8250/8250.h
index 34eb676916fe372e43a948895b512bc5ca51ed09..1ebf8538b4fa8aa31eacd34bc9c8cb2c2159770f 100644 (file)
--- a/drivers/tty/serial/8250/8250.h
+++ b/drivers/tty/serial/8250/8250.h
@@ -117,13 +117,6 @@ static inline void serial_dl_write(struct uart_8250_port *up, int value)
  * is cleared, the machine locks up with endless interrupts.
  */
 #define ALPHA_KLUDGE_MCR  (UART_MCR_OUT2 | UART_MCR_OUT1)
-#elif defined(CONFIG_SBC8560)
-/*
- * WindRiver did something similarly broken on their SBC8560 board. The
- * UART tristates its IRQ output while OUT2 is clear, but they pulled
- * the interrupt line _up_ instead of down, so if we register the IRQ
- * while the UART is in that state, we die in an IRQ storm. */
-#define ALPHA_KLUDGE_MCR (UART_MCR_OUT2)
 #else
 #define ALPHA_KLUDGE_MCR 0
 #endif