tg3: Remove unused link config code

When tg3 devices are shutdown, the driver uses the
TG3_PHYFLG_IS_LOW_POWER flag to enable a static phy configuration.
Any attempt to use the link configuration variables is dead code.  This
patch removes such code.

Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c
index 27cf74c747924f7d094d33d110635c3c083ed038..610997cec7c90281f5b5e59a6293e129194734b7 100644 (file)
--- a/drivers/net/ethernet/broadcom/tg3.c
+++ b/drivers/net/ethernet/broadcom/tg3.c
@@ -3607,12 +3607,8 @@ static int tg3_power_down_prepare(struct tg3 *tp)
                        tp->link_config.orig_autoneg = tp->link_config.autoneg;
                }
 
-               if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES)) {
-                       tp->link_config.speed = SPEED_10;
-                       tp->link_config.duplex = DUPLEX_HALF;
-                       tp->link_config.autoneg = AUTONEG_ENABLE;
+               if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES))
                        tg3_setup_phy(tp, 0);
-               }
        }
 
        if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5906) {